Table of Contents
Advertisement
connection on the DEFAULT route. This has been preset in the unit's factory
defaults.
Next, enter the remote station for routing via NetBIOS. Change over to the ELSA
LANconfig 'NetBIOS' configuration section and create a new entry in the 'NetBIOS
over IP Routing' table.
Alternatively, enter the following when configuring via telnet:
cd /Setup/NetBIOS-module/Remote-table
set nhamel.mobil router
The entry in the 'Type' field specifies whether a connection to the remote station
should be dialed up to exchange name information after switching on the NetBIOS
module.
The 'NT-domain' parameter can generally be left blank in the case of Windows 95 or 98
networks. The corresponding domain/workgroup must be entered manually when
accessing Windows NT machines.
If the NetBIOS link uses a PPP connection, check the PPP list for the activation of
NetBIOS for the corresponding entry.
Once all remote stations have been entered, activate the NetBIOS function.
cd /Setup/NetBIOS-module
set operating on
After switching the module on, a connection is established after an unspecified
waiting time to all remote stations not identified as dial-up nodes. The required
Operating modes and functions
ELSA LANCOM Business
89
Advertisement
Table of Contents
Need help?
Do you have a question about the LANCOM Business LC-4X00 and is the answer not in the manual?