Connecting Your Spm 3005 - Chord SPM 600 User Manual

multi-channel power amplifiers
connecting your SPM 3005
You need to connect the outputs from your AV processor to your power amplifier and
then connect your power amplifier to your loudspeakers. There are five pairs of
inputs that are split into two sections, the top for the front three speakers and the
bottom for the two rear speakers.
You can connect to either the XLR or RCA outputs, but not to both types at the
same time. All connections should be made with the power turned off.
There are also two RS232 ports for connection to a Creston™ or similar audio visual
remote control system. They are connected in parallel so that they can be used as
inputs or outputs to link to another piece of equipment.
connecting to your power amplifier using XLR style inputs
Use XLR style connectors to connect:
• the Right front output from your AV processor to the Right front balanced input
• the Centre output from your AV processor to the Centre balanced input
• the Left front output from your AV processor to the Left front balanced input
• the Right rear output from your AV processor to the Right rear balanced input
• the Left rear output from your AV processor to the Left rear balanced input.
connecting to your power amplifier using unbalanced RCA style inputs
Use RCA style connectors to connect:
• the Right front output from your AV processor to the Right front phono socket
• the Centre output from your AV processor to the Centre phono socket
• the Left front output from your AV processor to the Left front phono socket
• the Right rear output from your AV processor to the Right rear phono socket
• the Left rear output from your AV processor to the Left rear phono socket
connecting your loudspeakers
Connect your loudspeakers to the right front, centre, left front, rear right and rear left
binding posts.
See Figure F on page 24.
13