Serial Connections; Link Controls; Delay Adjustments; Filter Reset Options - SABINE Power-Q Operating Information Manual

Delay adjustments. Use the arrow keys to adjust the delay
up or down, for one channel at a time.
Filter reset options. Clicking this button opens up the screen
at right:
You may reset all or selected filter varieties, in either or both
channels, for the POWER-Q you have selected to control.
Unlike the POWER-Q itself, the remote software allows mul-
tiple filter types to be reset with one command execution.
If there is more than a single POWER-Q connected to the network,
these boxes represent the POWER-Qs connected in the serial
network. They may be identified by serial number, or by a user-
defined name. The POWER-Q indicated by a white highlight is the
unit controlled by the remote software. The selected POWER-Q
may be changed with a mouse click, or by holding down the control
key and pressing the corresponding function key (control/F1 selects
POWER-Q #1, etc.), with the exception that F10 cannot be used to
select a POWER-Q
The LINK CONTROLS allow any combination of POWER-Qs to be linked
together and controlled with one adjustment from the POWER-Q REMOTE
SCREEN. LINK LIST allows selection of POWER-Qs to be linked together:
simply click on the POWER-Qs in the list that you wish to be linked. Linked
units will be indicated by a white highlight. LINK MODE allows two choices
of POWER-Q control linkage: Absolute and Relative. In Absolute Link
Mode, any adjustment made on the REMOTE SCREEN is instantly copied
to all the Linked POWER-Qs, i.e., all linked units will adjust to the exact
same parameter value. In Relative Link Mode, any adjustments made on
the REMOTE SCREEN will add or subtract from the existing parameter
value already set in each unit.
In other words, Relative Mode should only be put in place after individual adjustment of each POWER-Q unit
in the network, and will be used to adjust Linked units in equal increments from each unit's unique baseline.
Note that many, but not all, of the POWER-Q parameters are subject to LINKED control. These parameters
are as follows:
*Compressor: threshold, ratio, knee
*Expander: threshold, ratio, knee
*Output level
*Bypass
*High and low pass filters
*Delay Settings
*Limiter: threshold, attack time, release time
*Noise gate: threshold, attack time, release time,
*Graphic EQ: boost/cut, filter width
*Phantom power
*FBX Filter: width, max depth, tracking, persistence, sensitivity
*20 dB reference microphone roll-off