Record; Record Timer; Storage; Memory - ETS 1 Operation Manual

3.5 Record

3.5.1 Record
In "Record Configuration", you can:
 Enable or disable the alarm record function. When "Enable" is set to "No", the alarm record function is
disabled even if you enable it in other configuration pages.
 Select if the data should be overwritten when the memory storage is full.
 Select the video resolution for event recording.
Note: The higher resolution you choose, the more accuracy and higher image quality the recording will
be, but the faster the memory storage is consumed and become full

3.5.2 Record Timer

To schedule alarm and motion recording, enable it, and select the day and time for recording.
Note: The timer must be enabled for the record function to work properly.

3.6 Storage

3.6.1 Memory

In "Memory", you can check the remaining capacity for recording, or clear all recorded data saved if needed.
Note: The recorded data will be removed also when you reset or reboot this camera.
Note: To know how and where to insert a micro SD card, please refer to the installation guide. To know
the compatible list of micro SD cards, please refer to "APPENDIX 7 MICRO SD CARD COMPATIBLE
LIST" at page 48.
Note: To save more recorded data, it's recommended to use this camera with the compatible NVR.
Note: To know the total recording time per recording resolution, please refer to "APPENDIX 6
RECORDING TIME TABLE" at page 47.
The total capacity may vary depending on different models. Please check the actual display of your model.
23