Oven Diagram - Electrolux E30MO65GSSA Service Manual

Electrical Requirements
The electrical requirements are a 5 -20 volt 60 Hz, AC only,
5 or more amp. fused electrical supply. It is recommended that a sepa-
rate circuit serving only this appliance be provided. When installing this
appliance, observe all applicable codes and ordinances.
A short power-supply cord is provided to reduce risks of becoming
entangled in or tripping over a longer cord.
Where a two-pronged wall-receptacle is encountered, it is the personal
responsibility and obligation of the customer to contact a qualified electri-
cian and have it replaced with a properly grounded three-pronged wall
receptacle or have a grounding adapter properly grounded and polar-
ized. If an extension cord must be used, it should be a 3-wire, 5 amp.
or more cord. Do not drape over a countertop or table where it can be
pulled on by children or tripped over accidentally.
CAUTION: DO NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE THE ROUND GROUNDING PRONG FROM
THIS PLUG.
11
2
6
. Ventilation openings. (Rear side)
2. Oven door with see-through window.
3. Oven lamp.
4. Turntable support.
5. Removable turntable.
The turntable will rotate clockwise or
counterclockwise.
6. Safety door latches.
The oven will not operate unless the door is
securely closed.
7. Wave guide cover.

OVEN DIAGRAM

7
1 3
10
9
8
14
15
6
8. Door open button.
9. Auto-Touch control panel.
0. Lighted digital display.
. Convection air openings.
2. Removable low rack. (Broiling trivet)
3. Removable low rack. (Baking rack)
4. Turntable motor shaft.
5. Power supply cord.
3-Pronged Plug
Grounding Pin
3-Pronged Receptacle
5
12
13
4
9
E30MO65GSSA
Grounded
Receptacle Box
TOUCH CONTROL PANEL