How To Maintain And Store The Unit - Bioland 2005 Instruction Manual

Upper arm automatic blood pressure monitor
Table of Contents

Advertisement

4. After measurement the screen will display systolic value, diastolic value, and pulse
per minute value, Then automatically store the measured record into memory.
5. Press "POWER" button again to turn off the unit.
* Even if you forget to press "POWER" button, the unit will turn
off automatically in approximately 2.5 minutes.
POWER
Note: * The value measured will be too low if you hold your cuff higher than heart level, or
will be too high if you hold your cuff lower than heart level.
* The unit may store 128 measurement values, If more than 128 records, it will
delete the earliest data.
* During measurement do not speak or shake as which may affect the accuracy of
the result.
* If you want to stop the measurement during measurement process, just press the
"POWER" button to stop immediately.
RECALLING MEMORY
1. Press "POWER" button to turn on the unit.
2. Press "
" button to review the first measurement in the memory. Repeatly Press "
button to review memory data in descending order.
3. Press "
" button to review the last measurement in memory. Repeatly press "
to review memory data in ascending order.

HOW TO MAINTAIN AND STORE THE UNIT

1. Use a dry soft cloth to clean the unit.. If necessary , use a cloth lightly dampened with tap
water.
" button
-11-
2. Do not use alcohol, benzene, thinner or other harsh chemicals to clean the device or cuff.
3. Before using please wash your hands. Do not wash or wet the cuff.
4. Avoid placing the unit where direct sunlight, high humidity or dust.
"
Note: When the unit will not be used for a long period, be sure to remove the batteries,
Otherwise, the batteries may leak and damage the unit.
HOW TO PREVENT A MALFUNCTION
1. Do not drop the device and avoid sudden jars or shocks.
2. Do not insert other objects into any holes.
3. Do not attempt to disassemble the unit.
4. Do not crush the pressure cuff.
5. If the unit has been stored at temperatures below 0
minutes before using it, otherwise, may get wrong messurement result.
C, leave it in a warm place for 30
O
-12-

Advertisement

Table of Contents
loading

Table of Contents