Charging Battery - SoftBank 840N User Manual

Charging Battery

Using AC Charger
Use only SoftBank-specified AC Charger
Blades
AC Outlet
3
AC
Charger
(ZTDAA1, sold separately).
External Device Port Port Cover
1
2
Connector
Release Tabs
Battery & Charger
1
Open Port Cover
2
Insert Charger connector into External Device Port
3
Extend Charger blades and plug into an AC Outlet
Charging Indicator lights red while charging. When charging is
complete, Indicator goes out.
4
Disconnect connector from handset
Press and hold Release Tabs to remove connector.
5
Unplug Charger from AC Outlet
6
Close Port Cover
Note
･ Battery can only be charged while inserted in handset.
When both Charging Indicator and Display Indicator
･
Charge Unusual Stop Charge appears, disconnect handset from AC
Charger and remove battery. Set up handset and Charger and start
charging again. If the same error occurs, AC Charger may be faulty or a
non-specified charger is being used. Contact SoftBank Mobile Customer
Center, Customer Assistance (P. 15-51).
･ When Battery is fully depleted, etc., it may take time for Charging
Indicator to illuminate.
1
go out and
1
-15