Disconnecting Cygnus Hpg; Charging From An Ac Supply - Firefly cygnus hpg User Manual

3.1.6 Disconnecting Cygnus HPG

1. Ensure that Cygnus HPG is turned off
HPG" on page 20
2. Switch off all breakers- see
Breakers" on page 15
3. If an input cable is connected, disconnect it- see
Outputs and Circuit Breakers" on page 15
4. Disconnect the output cable(s) - see
Breakers" on page 15
5. Remove the earth cable by unscrewing the Earth Point wing nut- see
"Fig. 2 - Earth Point" on page 12
6. Replace the washer and wing nut onto the Earth Point bolt.
3.2 Charging From An AC Supply
The unit can be charged via a 220 - 240 V AC supply from either the AC grid
supply or a secondary power system. To connect an AC supply to Cygnus HPG:
1. Connect the AC Input (See
Automatic Stop/Start" on page
presence of the input.
2. Select the required mode for the chosen input (See
Of The Power Modes" on page
3. View the Battery Monitor display to confirm that the battery bank is
charging and for detailed status (see
State of Charge" on page
"3.1.5 Turning Off The Cygnus
"Fig. 6 - Inputs, Outputs and Circuit
"Fig. 6 - Inputs, Outputs and Circuit
"4.1 Connecting To A Fuel Generator For
27)- Input LEDs will confirm the
17)
"3.1.3 Monitoring Battery Bank
19)
"Fig. 6 - Inputs,
The unit can be used while
charging-
"3.1.1 Description
automatically passes through to
consumers as required.
Charging time will increase
when consumers are using
available input current
The input is factory set to accept
a 63 A input. It is possible to
adjust the unit to accept inputs
with lower input currents.
CYGHPG12-24-User-Manual-v1.6.indd
the power
Page 21