Energy Saver Menu; Attach Lights To Sensors Menu; System Version Menu - ITI Concord Installation Instructions Manual

Energy Saver Menu

The ENERGY SAVER menu lets you set the energy saver mod-
ule low- and high-setpoints. These setpoints determine when
the module relay closes, thereby completing the circuit through
the thermostat to the furnace/air-conditioner.
Low Setpoint
(070)
(Default = 50°F) This setting determines the temperature at
which the energy saver module relay closes to activate the fur-
nace.
Note
The low setpoint cannot be set equal to or higher than
the high setpoint.
To set the Low Setpoint:
1. With the display showing ENERGY SAVER, press
A or B until the display shows LOW SETPOINT nn
DEGREES (current setting).
2. Enter the desired temperature (45–89°). The display
flashes the entered setting. Press
the new setting.
High Setpoint
(071)
(Default = 90°F) This setting determines the temperature at
which the energy saver module relay closes to activate the air-
conditioner.
Note
The high setpoint cannot be set equal to or lower than
the low setpoint.
To set the High Setpoint:
1. With the display showing ENERGY SAVER, press
A or B until the display shows HIGH SETPOINT nn
DEGREES (current setting).
2. Enter the desired temperature (46–90°). The display
flashes the entered setting. Press
the new setting.
DRAFT 8/17/00
(Energy Saver)
ƒ , then
ƒ and the display shows
(Energy Saver)
ƒ , then
ƒ and the display shows

Attach Lights to Sensors Menu

The ATTACH LIGHTS TO SENSORS menu lets you assign a
light number to a sensor. Each time the sensor is activated, the
attached light will turn on for 5 minutes. When the 5 minute
timer expires the light will turn off. If the same light is sched-
uled, it will only turn on during the schedule time.
Light x to Sensor Y
(08n where n = light number [1–9] minus 1)
(Default = 0) This menu attaches light x to sensor y. Each
time a selected sensor is tripped, the selected light will turn on
and a 5 minute timer will start.
Note
The sensor must be learned into the current partition
before it can be attached.
To attach a light to a sensor:
1. With the display showing LIGHT 1 TO SENSOR y (cur-
A or B to select the desired light
rent setting), press
number.
2. Enter the desired sensor number (01–76). The display
flashes the entered setting. Press
the new setting.
3. Repeat steps 1 through 2 until all desired lights are
attached to sensors.
To detach a light from a sensor:
1. With the display showing LIGHT 1 TO SENSOR y (cur-
A or B to select the desired light
rent setting), press
number.
2. Enter 0 as the sensor number and press

System Version Menu

The SYSTEM VERSION menu lets you view and identify panel
hardware and software. This information is primarily used for
troubleshooting purposes.
System Version
(010 = factory code, 011= system number,
012= system level)
(Default = N/A) This menu lets you view and identify panel
hardware and software version.
To view and identify the System Version:
A or B until the display shows SYSTEM VERSION.
1. Press
ƒ and the display shows FACTORY CODE
2. Press
nnn nnnn.
B and the display shows SYSTEM NUMBER
3. Press
nnnnnnn.
B again and the display shows SYSTEM LEVEL
4. Press
nnnn.
Programming the Panel
(Attach Lights to Sensors)
ƒ and the display shows
ƒ .
55