Advertisement
uni
(7)
!
+12
IN
GND
-12
red
IN
IN
IN
IN
IN
IN
uni2
Take it Carefully
technical details
� 16HP width
� 35mm deep (skiff friendly)
� power consumption: +12: <35mA
� PTC fuse and diode protected 10 pin power connector
� handmade in Brno, Czech republic
www.bastl-instruments.com
� master or slave tempo sync – selectable slave tempo
clock divider
� 6 voices with individual outputs – each can be set as
trigger or gate
� each pattern has 4 bars with 16 steps each
each step has 4 sub steps
(so there's a total of 256 steps per pattern)
� 64 patterns total
� simple and fast real-time editing
� record function with quantisation settings
� play / stop button (for sync in slave mode)
� mute function for each voice
� jump function (repeats a certain step)
� adjustable master tempo by tap or up, down
(in 2 bpm increments)
� active step – sets how many steps there are for each
voice or for all instruments – it's possible to deactivate
individual steps
� saves everything on a microSD card
(accessible from the back side)
� copy & paste functions for fast workflow
(paste a voice, bar or pattern)
� clear function (for one voice, all voices, active steps
in one voice, all active steps)
� undo function takes you back to your last saved state
Before connecting the ribbon cable to this module disco-
nnect your system from power !
!
Double check the polarity of the ribbon cable and that it
is not shifted in any direction. the red cable should match
the -12V rail both on the module and on the bus board !
please make sure of the following
� you have a standard pinout eurorack bus board
� you have +12V and -12V rails on that bus board
� the power rails are not overloaded by current
Although we put protection circuits in the device, we
do not take any responsibility for damages caused by
wrong power supply connection.
After you connected everything, double-checked
it and closed your system, so no power lines can be
touched by hand, turn on your system and test the
module.
Advertisement
