Sony HDR-AZ1 How To Use Manual page 59

(default): Does not record the time as the user bit
To reset
All of the values will be 0 if you press the DISP button of the remote control while selecting
TC PRESET or UB PRESET using the remote control. All of the values will be reset if you
press the REC/ENTER button of the remote control once again.
Note
Time code/User bit can be set only for the movie mode.
Use an SDXC card faster than Class10 when recording movies in XAVC S.
When the remote control is not connected to the camera through Wi-Fi, the camera
settings cannot be changed.
To return to the setting item selection screen from the setting value selection screen,
select .
To perform the setting item in the selection screen or the setting value, select
Hint
About time code
Time code is a useful function for advanced image editing, by recording
hours/minutes/seconds/frames on the image data.
When TV system is set to [NTSC] and the frame rate is 30p or 60p, gaps between the
actual time and the time code occur during extended periods of recording as there is a
slight difference between the number of frames of the time code and the actual frame
frequency of NTSC image signal per second. Drop frame corrects these gaps to ensure
that the time code matches the actual time. The first frame numbers (the first 2 frame
numbers for 30p or the first 4 for 60p) are removed every minute except in every ten
minute. Time code without this correction is called non-drop frame.
About the user bit
User bit is a function that can record information (8-digit hexadecimal numbers) such as
date/time/scene number. This function is useful to edit movies using two or more
cameras.
[55] How to Use
Settings
IR-Remote Controller
You can operate the camera using an infrared remote controller (RMT-845 (sold
separately)).
Changing the Settings of the Live-View Remote
.
Connecting Devices