Table of Contents
Advertisement
If the engine stalls and the SECURITY light flashes,
wait about
10
minutes until the light stops flashing
before trying to restart the engine. Remember to release
the key from the START position as soon as the
engine starts.
If the engine does not start after three (3) tries, the
vehicle needs service.
If you are driving and the S E C U m E g h t comes on,
you will be able to restart the engine if you
turn
the
engine off. However, your Passlock system is not
working properly and must be serviced by your dealer.
Your vehicle is not protected by Passlock at this time.
You may also want to check the fuse (see "Fuses and
Circuit Breakers" in the Index). See your dealer
for service.
If the SECURITY light flashes, wait until the light stops
flashing before starting the engine.
If the SECURITY light comes on while the engine is
running, a problem has been detected and the system
may need service. See your dealer for service.
In an emergency, call the GM Roadside Assistance
Center. See "Roadside Assistance'' in the Index.
New Vehicle "Break-In"
NOTICE:
Your vehicle doesn't need an elaborate
"break-in." But it will perform better in the long
run if you follow these guidelines:
Keep your speed at 55 mph (88 km/h) or
less for the first
500
miles
(805
km).
Don't drive at any one speed
--
fast or
slow
--
for the first
500
miles
(805
km).
Don't make full-throttle starts.
200 miles (322 km) or so. During this time
your new brake linings aren't yet broken
in. Hard stops with new linings can mean
premature wear and earlier replacement.
Follow this breaking-in guideline every
time you get new brake linings.
See "Towing a Trailer'' in the Index for
more information.
Avoid making hard stops for the
first
Don't tow a trailer during break-in.
2-13
Advertisement
Table of Contents
