Fixture Hours; Software Version - ADJ Event Bar Q4 User Instructions

Event Bar Q4
unit will automatically go into Master Slave mode.
• Blackout - If the DMX signal is lost or power is applied, the unit
will automatically go into stand by mode.
• Last State - If the DMX signal is lost the fixture will stay in the
last DMX set up. If power is applied and this mode is set, the unit
will automatically go into the last DMX set up.
3. Press ENTER to confirm your desired set up.
Back Light
- With this function you can make the back-
light automatically turn off after one minute.
1. Press the MENU button until "Back Light" is displayed, press
ENTER.
2. Either "ON" or "OFF" will now be displayed. Press the UP or
DOWN buttons to select "ON" to keep the backlight on at all
times, or "OFF" to allow the backlight to turn off after 2 minutes.
Press any button to turn the backlight on again.
3. Press ENTER to confirm.
Auto Test
- This function will run a self test program.
1. Press the MENU button until "Auto Test" is displayed, press
ENTER.
2. The fixture will now run a self test. Press the MENU button to
exit.
Pan Inverse
- Pan Inversion
1. Press the MENU button until "Pan Inverse" is displayed,
press ENTER. Either "Normal" or "Inverse" will be displayed.
2. To activate the Pan inversion press the UP or DOWN buttons
until "Inverse" is displayed, press ENTER to confim. To deacti-
ADJ Produc s, LLC - www.adj.com - Event Bar Q4 Instruction Manual Page 12
t
System Menu Event Bar Q4
vate Pan inversion, select "Normal" and press Enter.
Tilt Inverse
1. Press the MENU button until "Tilt Inverse" is displayed, press
ENTER. Either "Normal" or "Inverse" will be displayed.
2. To activate the Tilt inversion press the UP or DOWN buttons
until "Inverse" is displayed, press ENTER to confim. To deacti-
vate Tilt inversion, select "Normal" and press Enter.

Fixture Hours

running time of the unit.
1. Press the MENU button until "Fixture Hours" is displayed,
press ENTER.
2. The running time of the fixture will now be displayed. Press
MENU to exit.

Software Version

sion
1. Press the MENU button until "Software Version" is displayed.
Press the ENTER button and the software vesion will be dis-
played.
2. Press the MENU button to leave this function.
Reset
1. Press the MENU button until "Reset" is displayed, press
ENTER.
2. The fixture will now reset.
- Tilt Inversion
- With this function you can display the
- This will display the software ver-
- Use this function to reset the unit.
ADJ Produc s, LLC - www.adj.com - Event Bar Q4 Instruction Manual Page 13
t
System Menu