ADJ Event Bar Q4 User Instructions page 6

Event Bar Q4
to Master and then set the next fixture to "Slave 2", the fixtures
will now have contrast movement to each other.
Show Mode
- Show modes 0-8 (Factory programs).
Show mode can run with or without sound active mode
active.
1. Press the MENU button until "Show Mode" is displayed, press
ENTER.
2. "Show X" will now be displayed, "X" representing a number
between 0-8. Programs 1-8 are factory programs, while "Show
0" is random mode. Press the UP or DOWN buttons to find your
desired show.
Install Mode
- This mode allows you to control the beam
spread of the fixture.
1. Press the MENU button until "Install Mode" is displayed,
press ENTER. Either "INS 1", "INS 2" or "INS 3" will be dis-
played.
• INS 1 - Long range beam (ceiling hanging)
• INS 2 - Short range beam (ceiling hanging)
• INS 3 - Front range beam (for truss or wall mounting)
2. Press the UP or DOWN buttons until your desired installation
setting is displayed, and press ENTER to confim.
Dimmer Curve
- In this mode you can select the dimmer
curve. See page 23 for the different dimmer curves.
1. Press the MENU button until "Dimmer Curve" is displayed,
press ENTER.
2. The current dimmer curve will be displayed.
3. Press the UP or DOWN buttons to find your desired dimmer
mode and press ENTER to confirm.
ADJ Produc s, LLC - www.adj.com - Event Bar Q4 Instruction Manual Page 10
t
System Menu Event Bar Q4
Sound State
active mode.
1. Press the MENU button until "Sound State" is displayed, press
ENTER.
2. Either "On" or "Off" will now be displayed. Use the UP or
DOWN buttons to toggle between "On" and "Off".
3. Press ENTER to confirm your selection, the press and hold the
MENU button to activate.
Sound Sense
sensitivity of the sound active mode.
1. Press the MENU button until "Sound Sense" is displayed,
press ENTER.
2. Press the UP or DOWN buttons to adjust the sensitivity level.
The sensitivity level can be adjusted between 0 (the lowest) and
100 (most sensitive).
3. Press ENTER to set you desired level.
DMX State
mode, that in case the DMX signal is lost, the operating mode
chosen in the setup is the running mode the fixture will go
into when the DMX signal is lost. You can also set this as
the operating mode you would like the unit to return to when
power is applied.
1. Press the MENU button until "DMX State" is displayed, press
ENTER.
2. Either "Master/Slave", "Blackout", or "Last State" will be dis-
played. Choose an operating mode you would like the unit to
start up in when power is applied or the DMX signal is lost.
• Master/Slave - If the DMX signal is lost or power is applied, the
- In this mode the unit will run in sound
- In this mode you can adjust the sound
- This mode can be used as a precaution
ADJ Produc s, LLC - www.adj.com - Event Bar Q4 Instruction Manual Page 11
t
System Menu