Sharp JH-3500U Installation & Operator's Manual page 12

2. Attach the bracket to the wall. A hole allocated on the upper side of the horizontal center is for
hanging the bracket.
Tighten included screw which is intended for hanging it on the wall (not completely tighten,
some spacing to hang the bracket is needed). This screw does not need the flat washer. And
then, hang the bracket to the screw.
3. Tighten ten pieces of included screws to fix the bracket. These screws need flat washers.
At the end, Tighten all the screws for hanging completely.
Remove metal debris created when tightening screws or drilling holes.
CAUTION
• Be sure to use the included mounting bracket to insure that the solar power conditioner is water resistant.
4. Remove the A screw on the bottom of the solar power conditioner.
5. Place the solar power conditioner so that it is hooked on the upper and center hooks on the
bracket.
6. Hold the solar power conditioner firmly and pull the bottom part of it forward to confirm that it is
hooked on the bracket securely.
9