Stihl FS 94 Instruction Manual page 24

English
Insert the stop pin (6) in the bore (7)
N
in the gearbox as far as stop, apply
slight pressure.
Rotate shaft, nut or cutting
N
attachment until the stop pin slips
into position and blocks the shaft.
Mount the cutting attachment.
WARNING
Use a deflector that matches the cutting
attachment – see "Mounting the
Deflector".
Fitting Mowing Head with Screw
Mounting
Keep the instruction leaflet for the
mowing head in a safe place.
22
1
Screw the mowing head
N
counterclockwise on to the shaft (1)
as far as stop.
Block the shaft.
N
Tighten down the mowing head
N
firmly.
NOTICE
Remove the tool used to block the shaft.
Removing the Mowing Head
Block the shaft.
N
Unscrew the mowing head
N
clockwise.
Mounting Metal Cutting Attachment
Keep the leaflet and packaging of the
metal cutting tool in a safe place.
WARNING
Wear protective gloves to reduce the
risk of direct contact with the sharp
cutting edges.
Mount only one metal cutting
attachment.
Check direction of rotation of cutting
attachment
1
The cutting edges of the grass cutting
blade (1) may point in either direction –
this cutting attachment must be turned
over regularly to reduce one-sided wear.
Cutting edges of grass cutting blade (2)
must point clockwise.
WARNING
Direction of rotation is indicated by an
arrow on the inside of the deflector.
STIHL FS 94 R
2