Installation And Setting Of R/C Units - Ko Propo EX-10 EURUS Instruction Manual

Installation and setting of R/C units

1.
Install and connect receiver, servo and ESC (for electric car) to your R/C car.
Be careful and note the anti-noise measures (refer to P11).
※Read instruction manual included in servo and ESC carefully.
2.
Install battery in transmitter and attach module (refer to P10-11). Then, install
running battery for an electric car or install receiver battery for a gas car.
3.
Register receiver to transmitter (pairing/see below).
※Before using a receiver for the first time, pairing is required.
If you several receivers for one transmitter, pair is also required for each receiver when used for the first time.
4.
Adjust steering, throttle and brake (refer to P18-24).
5.
Set fail-safe function (see below).
※If R/C model runs out of control (in case receiver loses radio wave from transmitter),
the fail-safe function will keep throttle (CH2) to brake or neutral position for safety use.
【How to pair】
①
Attach module (RF-902S) to transmitter and raise
antenna.
②
Keep pressing set button of the module and turn
transmitter on (LED on module will light up).
③
After approx. 3 seconds, LED will light off. Then release
set button (LED will be dim and ready for pairing).
④
Move receiver antenna close to transmitter (approx. within 1m).
⑤
Hold the set button of the receiver and turn the receiver power
ON by either connecting the battery cable or turning on the ESC.
⑥
Release the set button and receiver's LED will be solid.
Turn off the receiver and transmitter to save the pairing.
Operation check：
Turn on transmitter and check if LED on module lights up.
Then turn on receiver and check if receiver' s LED lights up.
※Try pairing later or in another location if someone is pairing
near by. WiFi and microwaves also affect pairing.
【Setting fail-safe function】
①
Turn on transmitter.
②
Turn on receiver. Check if servo operates correctly.
③
Keep throttle trigger in brake or neutral position.
④
Hold the set button on the receiver for 3 seconds.
⑤
After the receiver's LED indicator goes off, release
the set button.
Operation check：
Turn on transmitter and receiver. Then turn off
transmitter and check if fail-safe function is effective.
※For safety use, please set fail-safe function.
※For gas car, reset fail-safe function if the brake linkage is changed.
If not reset, the former setting will be used and may not be correct.
②
＋
④
⑤
Battery connector
Receiver s LED
indicator lights up
※Check operation by turning OFF the receiver, transmitter
and then turning ON the transmitter and receiver.
③ ④
Choose brake or Hold the set
neutral and hold the button of the
trigger position. receiver.
Brake
For 3 seconds.
Neutral
※Check operation by turning OFF the receiver,
transmitter and then turning ON the transmitter
and receiver.
③
LED
lights off
Within 1m
Pairing
completed!
⑤
Set up complete
and release set
button.
LED
lights off
13