Ko Propo EX-10 EURUS Instruction Manual page 12

● Receiver installation on carbon chassis
When fixing the receiver to the chassis or on the
mechanism deck, use more than 2 layers of
double-sided tape to avoid direct contact with
chassis. Chassis and mechanism deck (especially
carbon material) can also conduct noise. Making
space between receiver with them is recommend to
ensure protection against noise.
※Note receiver' s LED position when installing.
● Antenna installation
Raise antenna cable vertically and set as high as possible. Pass cable into antenna pipe to protect from
damage. Make the tip of antenna cable aligned with antenna pipe end. Installing antenna holder far away
from receiver may deteriorate radio sensitivity. Locate antenna holder as near to the receiver as possible.
Make sure that the antenna cable does not come in direct contact with chassis, mechanism plate or other
noise sources. Make sure to use plastic antenna pipe and mount. Do not use metal antenna mount as it
easily conducts noise and may cause troubles.
Tip of antenna pipe
Antenna cable
※Do not cut or bundle antenna cable.
(It may result in breaking of wire and
deteriorate performance.)
Piano wire
Aluminum holder
Soldering lug plate
● Attaching to a gas car
Engine vibration may damage the receiver. Make sure to attach
grommet (receiver holder) to reduce vibration. Do not attach
directly to chassis or mechanism plate using double-sided tape.
The installation position should be as far as possible from heat
from engine or exhaust.
※Note receiver's LED position when installing.
12
Plastic
antenna pipe
Aluminum holder
(Usable with FRP or plastic chassis)
Double sided tape
Plastic
antenna pipe
Plastic holder
Grommet