Wifi Control & Operation; Preparation Before Taking Off; Cautions On Controlling; Battery Installment - Quadrone i-sight Instruction Manual

5. WIFI CONTROL & OPERATION

1. Preparation before taking off

(1) Insert the AA batteries in the controller as shown in the picture below.
(2) Please place the drone on a flat, level surface.
(3) Stand at least 5 feet behind the drone.
(4) Please double check for any obstacles or potential hazards near the area of flight.
(5) Please see below how to sync this drone with your remote. Once they are paired, you are ready
for take off.

2. Cautions on controlling

Control range: The flight distance is about 330 feet. If flown beyond this distance, you will lose control of
your drone.
WARNING: Flying your drone in strong winds can cause you to lose control of your drone and possible damage
might occur.
Flying time: The flying time is about 6-8 minutes.
Prevent the drone from crashing
from a large height to prevent
any possible damage.

Battery Installment

Battery Installation: Open the battery cover on the back of the remote control and insert 4 AA batteries,
according to the polarity illustrated on the remote. (Batteries not included)
3. Pairing the remote and drone
Picture 1
1. Push down the power joystick to the bottom position, when the
controller is still turned off. Connect the Li-battery with the drone as
shown in pic 1. Turn on the controller to pair it with the drone. When you
hear two beeps and the lights stay on, it means the match was
successful. (Note: If you have not push down the joystick in advance, it
may not match the signal).
Aircraft should always be flown
at least 3 feet off the ground
at all times.
Battery
cover
4X1.5V
AA
batteries
6
Do not fly near obstacles or
hazards to avoid any possible
damage.
1. Install batteries to the correct polarity.
2. Do not mix old and new batteries.
3. Do not mix different types of batteries.
Picture 2
3. Once the drone and the remote are paired
together, they are ready for take off!