Quadrone TUMBLER Instruction Manual
  1. Manuals
  2. Brands
  3. Quadrone Manuals
  4. Drones
  5. TUMBLER
  6. Instruction manual

Quadrone TUMBLER Instruction Manual

Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

Contents
1
1-2
3
4
5
6
7
8
9
10
11
INSTRUCTION MANUAL
Please read through this manual before flying this product.
Please keep this manual for future reference.
Tested to comply with FCC standards.
FOR HOME OR OFFICE USE.
This device complies with part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful
interference and
(2) This device must accept any interference
received, including interference that may
cause undesired operation.
PROP 65 WARNING
WARNING: This product may
WARNING:
contain a chemical known to
the State of California to cause
CHOKING HAZARD-Small parts.
cancer, or birth defects, or
Not for children under 3 years.
other reproductive harm.
Manufactured in China.
Batch Ref: XXXX
Model Number: XXXX

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TUMBLER and is the answer not in the manual?

Questions and answers

Related Manuals for Quadrone TUMBLER

Summary of Contents for Quadrone TUMBLER

  • Page 1: Table Of Contents

    INSTRUCTION MANUAL Contents INTRODUCTION SAFETY NOTES GENERAL PACKAGE CONTENTS DRONE DIAGRAM REMOTE CONTROLLER DIAGRAM REMOTE BATTERY INSTALLATION Please read through this manual before flying this product. CHARGING THE LI-PO BATTERY Please keep this manual for future reference. SYNCING THE DRONE TO THE REMOTE CONTROLLER Tested to comply with FCC standards.

  • Page 2: Introduction

    1 . INTRODUCTION ●This product is NOT A TOY. Incorrect use can cause damage or injury. Please use this product according to this manual. And please do not disassemble this product by yourself. ●This flying model requires practice before use. Manufacturer shall not be responsible to any damage of the product or injury to any person.

  • Page 3: Remote Controller Diagram

    5. REMOTE CONTROLLER DIAGRAM DO NOT DISASSEMBLE A N TE N N A POWER F L IP PIN G INDICATOR BU T TO N LIGHT CONTROL F O RW AR D AN D B AC KW AR D F IN E - TU N IN G FAS T AN D S LO W SPEED F O RW AR D\ B AC KW AR D\...

  • Page 4: Charging The Li-Po Battery

    7. CHARGING THE LI-PO BATTERY Use the charger provided to charge the battery. Charger WARNING Please use the charger included in the package only. Connect the charger and the battery as the picture shown. CAUTION For safety concerns, battery must be charged under adult supervision at all times.

  • Page 5: Flight Adjustment And Setting

    Step 4 Turn off the transmitter. If transmitter is not to be used for a long duration, please remove the battery for storage. ON/OFF 9. FLIGHT ADJUSTMENT AND SETTING It is important to practice maneuvers before flying your drone. Before flying: Please practice the following moves shown in the below pictures until you get used to using the remote controller.

  • Page 6: Fine Tuning

    Fine Tuning Slowly raise the throttle stick and just as the helicopter lift-off the ground, you can use the trim to correct the action if the drone leans in a different direction. Mode 1. ADJUSTMENT OF TURNING TRIM Right Just before the drone lifts-off, the nose lean left/right: When leaning right, adjust the trim to left side.

  • Page 7: Troubleshooting

    10. TROUBLESHOOTING Problem Cause Solution LED blinks continuously after Repeat the power up initializing flight vehicle battery inserted. Unable to sync to transmitter. process. No response to controller. 1. Turn on remote and ensure 1. No power to drone drone battery is inserted properly. 2.

  • Page 8: Parts List

    11. PARTS LIST Name Quantity 4 Axis cover 4 Axis base Receiver board Li-polymer Battery Motor A Blade B Blade Light strip Protective frame BATTERY WARNING: AWW INDUSTRIES™ is an innovative division of DGL Group, Ltd. Other trademarks and trade names are those of their respective owners. •...

Table of Contents