Recalibrating The Drone's Gyroscope; Spare Parts - Quadrone i-sight Instruction Manual

7. Recalibrating the Drone's Gyroscope

If flight cannot be corrected through fine tune trimming, try the following directions to recalibrate the drone's inner gyroscope:
(1) Place the drone on a flat, level surface.
(2) After matching the drone and remote, switch the speed to high speed, and then push the joysticks to the bottom right corner as
shown. When you hear two beeps and a red light flashes, it means the recalibration has been successful.
The drone must be on a flat surface to be recalibrated.

SPARE PARTS

All the spare parts below can bought from your local distributor.
Body cover
Landing skids
Light boards
Camera K300C/Wifi
The bottom
Motor holder
Receiver board
Controller
10
Joysticks must be on the bottom right corner at the same
time
Main blades
Lampshades
Battery
Protecting frames
Motor A/B
charging cable
USB