Table of Contents
Advertisement
SCREEN SAVER
Choose to enable the panel saving functions to
reduce the risk of the "image persistence".
SCREEN SAVER
COOLING FAN
BRIGHTNESS
MOTION
:SEL
+-:ADJ
EXIT
• {COOLING FAN} - Select {ON} to turn on the
cooling fan all the time. Select {AUTO} to turn
on/off the cooling fan according to the display's
temperature.
NOTES:
• The default {AUTO} option will start running
the cooling fan if the temperature of 65°C
(152°F) is reached, and will keep running
for 30 minutes after cooling down to the
temperature of 62°C (144°F).
• A temperature-warning message will be
shown on the screen once the temperature
reaches 79°C. All key function except
[Power] key will then be disabled.
• {BRIGHTNESS} - Select {ON} and the
brightness of the image will be reduced to an
appropriate level, and the Brightness setting in
the Picture menu will become unavailable.
• {MOTION} - Select the time interval ({10 ~ 900}
Seconds / {OFF}) for the display to slightly
expand the image size and shift the position of
pixels in four directions (up, down, left, or right).
SIDE BORDER COLOR
Adjust the brightness of the black areas displayed
on both sides of 4:3 images.
CONFIGURATION3 RESET
Reset all settings in the CONFIGURATION3 menu
to factory preset values.
AUTO
OFF
OFF
:RETURN
:EXIT MENU
MENU
4.2.8. ADVANCED OPTION menu
INPUT CHANGE
TERMINAL SETTING
SCAN CONVERSION
COLOR SYSTEM
SCAN MODE
SERIAL CONTROL
PIP
LAN SETTING
1
APM
ADVANCED OPTION RESET
2
FACTORY RESET
3
:SEL
:NEXT
SET
INPUT CHANGE
Select the time for input switching as {NORMAL}
or {QUICK}.
NOTE: The selection {QUICK} may cause a slight
noise.
TERMINAL SETTING
Select the mode to display the HDMI or DVI signal
according to their signal format depending on their
source device.
• {DVI MODE}: Used for DVI-D signal.
• Select {DVI-PC} when the source device is a
PC.
• Select {DVI-HD} when the source device is a
video device.
• {HDMI SIGNAL}: Used for HDMI signal.
• Select {LIMITED} when displaying the signal
that uses 16 to 235 levels of 256 levels for
each R, G, and B.
• Select {FULL} when displaying the signal
that uses all 256 levels (from level 0 to 255).
DVI-MODE
HDMI SIGNAL
PIP
1
2
3
:SEL
+-:ADJ
22
ADVANCED OPTION
NORMAL
LAN
OFF
:RETURN
:EXIT MENU
EXIT
MENU
TERMINAL SETTING
DVI-PC
FULL
:RETURN
:EXIT MENU
EXIT
MENU
Advertisement
Table of Contents
Troubleshooting
