Make Electrical Connection - Whirlpool GBD277PR Installation Instructions Manual

3. Grasp the edges of the oven door with both hands and close
the oven door until it will no longer close. Lift and pull oven
door toward you and remove. Set the oven door aside on a
protective surface.
4. Remove bottom screw on each side of the oven trim.
A. Remove trim screw and pull out
5. Grasp the bottom end of trim and pull away from oven.
6. Slide top end of trim downward to remove trim from oven. Set
trim aside.
Disconnect power before servicing.
Use 8 gauge solid copper wire.
Electrically ground oven.
Failure to follow these instructions can result in death,
fire, or electrical shock.
This oven is manufactured with a neutral (white) power supply
wire and a cabinet-connected bare grounding wire crimped
together.
1. Disconnect power.
A
2. Feed the flexible cable conduit from the oven through the
opening in the cabinet.
3. Remove junction box cover if present.
4. Connect the flexible cable conduit from the oven to the
junction box using a UL listed or CSA approved conduit
connector.
5. Tighten screws on conduit connector.
6. Complete installation following instructions for your type of
electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)
Electrical Connection Options
If your home has:
4-wire direct
3-wire direct

Make Electrical Connection

WARNING
Electrical Shock Hazard
And you will be
connecting to:
A fused
disconnect or
circuit breaker
box
5"
(12.7 cm)
A fused
disconnect or
circuit breaker
box
Go to section:
4-wire Cable from
Power Supply
3-wire Cable from
Power Supply
5