Controls - GE ZGW124EN User Manual

PROBLEM
COMPONENTS ARE
NOT FUNCTIONING
PROPERLY
FEELS HOT
SOLID DISK
ELEMENTS WILL
NOT MAINTAIN A
ROLLING BOIL OR
FRYING RATE IS NOT
FAST ENOUGH
MODULE IS NOT
PROPERLY
TO GRILL OR
EXCESSIVE SMOKE
FROM GRmLED
MEATS
SOLID DISK
ELEMENTS SMOKE
WHILE HEATING
30
circuit fuse, a tripped circuit breaker, the main fuse or the main circuit breaker,
depending on the nature of the power supply, If a circuit breaker is involved, reset it.
It the control box uses fuses, the circuit fuse (a cartridge-typ~) should be changed,
BUT ONLY BY SOMEONE FAMILIAR WITH ELECTRICAL CIRCUITS.
If, after performing one of these procedures, the fuse blows or circuit breaker trips
again, call for service.
Note: Apartment tenants or condominium owners should request their building
management perform this check before calling for service,
Controls are not properly set or wrong control is set for the component or element
you are using.
Entire grill or griddle element is not plugged in properly.
Consider the possibility of interruption in gas or electric service from the utility source.
seem hotter than you are used to. This is normal. Mak@ sure flat-bottom pans am used.
bottom and a straight edge, the elements will not transfer heat properly.
Pan bottoms should closely match the diameter of the heating area selected.
Grill eIement is not plugged in solidly.
Grill or griddle element controls are not properly set.
Griddle was not pre-seasoned before first use.
Heat setting is too high.
Coating of griddle has been damaged by use of sharp instruments or abrasive cleaners.
excessive smoke.
Fats not trimmed from meats prior to cooking.
Some smoke and odor is normal when using solid disk elements for the first time and