Table of Contents
Advertisement
Window Mounting
Window Requirement
(continued)
clearance below the window
stool is required.
If the storm window frame does not
allow this clearance, attach a
or 2~wide strip of wood along the
entire length of the window opening,
flush with the back side of the stool,
or remove the storm window for
the air conditioning season.
1 /2"
min.
,/
Storm
Window
or
Other
Obstruction
1. Remove the Chassis.
Slide chassis from cabinet by
holding with left hand while pulling
on handle at bottom front of unit.
Be careful of sharp edges on the coil
fins.
If your unit has corrugated packing
material inside the cabinet, it must
be removed. Do not remove the
foam pads inside the cabinet.
Note: Handle is N~ intended
for lifting the unit. It is only for
sliding the chassis out of the
cabinet for cleaning or maintenance.
2. Install Top Angle
and Side Retainers.
1. Attach foam gasket ,
to top angle as shown. ~~~•
Plastic
Frame
\
stool
Frame
c
3. Assemble Window
1. Place cabinet on floor, bench or
table.
2. Slide the "1'
window filler panel into the panel
retainer on the side of the cabinet
as shown above. Do both sides.
3. Insert top and bottom legs of the
window filler panel frame into the
channel in the top support angle
and bottom rail. Do both sides.
0
Top View
Air
7
section of the
9
2. Install top rail and side retainers
to cabinet as shown, using 10 Type
F screws.
Conditioner
,.
Cabinet
"l" Section' "--
Window
Filler
Panel
4. Insert two Type A screws into
holes in the top leg of the filler
panel frame. Do not tighten—legs
should slide easily.
Plastic
Frame
Hole
Advertisement
Table of Contents
