Hotpoint KED12 Use And Care & Installation page 10

Table of Contents

Advertisement

Window Mounting
4. bcate Cabinet
in Window.
1. Open window and mark center
of window stool.
2. Place cabinet in window with
bottom stool angle firmly seated
over window stool as shown. Bring
window down temporarily behind
top rail to hold cabinet in place.
I
I
stool
Stool Angle
3. Shift cabinet left or right as
needed to line up center of cabinet
on center line marked on stool.
Type B S;rews
4. Fasten cabinet to window stool
with 2 ~pe B screws. (You may
want to drill pilot holes. )
5. Instill Support Brackeh.
T pe C Screws and Locknuts
(1 requiredfor each support bracket)
1. Hold each support bracket flush
against outside of sill and tight to
bottom of cabinet as shown. Mark
brackets at top level of sill and
remove them.
(continued)
2
I
Assemble sill angle brackets
to support brackets at positions
previously marked, as shown. Hand
tighten only—some adjustment may
be required later.
3. Install support brackets, with sill
angle brackets attached, to cabinet
as shown.
4. Tighten all 6 bolts securely.
6. Etiend Window Piller
1. Carefully raise window to
expose filler panel locking screws.
2. Extend panels to fill window
opening completely and tighten
locking screws on top.
3. Close window behind top rail.
10
7. Instill Windowbck
and Sash Seal.
1. Trim sash seal to fit window
width and insert into space between
upper and lower sashes.
2. Attach right angle safety lock
with ~pe B-screw-as shown.
3. Position bottom rail seal on
bottom rail flush with front edge of
rail and in contact with side seals.
Be sure handle at bottom of unit is
up. Then Iifi chassis and carefilly
slide it into cabinet. Do not push on
controls or finned coils. Make sure
chassis is firmly seated toward rear
of cabinet.
9. Instill Dial Plate,
If dial plate has a protective film,
peel the film off carefully. Do not
scratch the surface of the plate.
10. At~chfiont Grille.
(a) Remove inlet baffle (see page 5). -
(b) Attach front grille to unit (see
page 11, step 6b).
(c) Reinstil irdet baffle (see page 5).

Advertisement

Table of Contents
loading

Table of Contents