GE GSD2800 Series Use And Care Manual page 9

DISPLAY WHAT IT MEANS
BLOCKED
Similar to slow drain. This
DRAIN
indicates that the drain is so
clogged that the dishwasher
cannot continue to operate in a
satisfactory manner. Dishwasher
will stop.
DRAIN Dishwasher will continue cycle
SENSOR along with a drain period.
DRAIN There is too much water in the
WATER dishwasher. If DRAIN WATER
appears after a power failure, this
is normal and the dishwasher will
correct itself.
This can be caused by either of
LOW
WATER these reasons:
Not enough water is entering the
dishwasher.
The drain pump could be
temporarily blocked (usually
caused by food particles such
as cereal).
WHAT TO DO
Locate and remove the blockage in the drain system.
To pump any remaining water out of the machine:
1. Latch door.
2. Select any cycle.
3. Touch "START" and then immediately touch "CLEAR
RESET." (NOTE: Warranty service does not cover
household drain problems.)
If DRAIN SENSOR repeats for the next cycle, call for
service.
The dishwasher is designed to automatically pump out extra
water as long as the door is latched. When you hear the motor
stop running:
1. Unlatch the door and see if all the water is gone. (It is
normal for a small amount of water to remain in the bottom
of tub to keep the water seal lubricated.)
2. If you see water entering the dishwasher, close and latch
the door. Shut off the water supply to the dishwasher.
3. If water is gone and no water is entering the dishwasher,
restart cycle.
4. If DRAIN WATER repeats, shut off the water supply to the
Unlatch the door. If there is no water in the bottom of the
dishwasher, check the water supply to the dishwasher.
. Is the dishwasher water supply turned on?
(Valve usually located under the sink.)
. Is the household water supply turned on?
or
If you use well or cistern water, is the supply adequate?
If the water supply is adequate, try the cycle again. If LOW
WATER repeats, call for service.
Unlatch the door. If there is standing water in the bottom of
the dishwasher, relatch the door, touch "START," then
immediately touch "CLEAR RESET" to start the pump.
If LOW WATER continues to appear, you may need to do
this several times to breakup the blockage.
dishwasher. Call for service.
(continued next page)
9