Air Direction - Hotpoint KCD09L Use And Care Manual

For normal cooling
1. Set the Master Control Switch at
HI COOL.
2. Set the Thermostat Control at
the desired number (usually 4-5 is
a good starting position). If room
temperature is not satisfactory after
a reasonable time, set the Thermostat
Control at a higher number for a
cooler room or at a lower number
for a warmer room.
3. Be sure the AIR IN and AIR OUT
buttons are in the out position.
For m~imum cooling
1. Set the Master Control Switch at
HI COOL.
2. Set the Thermostat Control at 8.
3. Be sure the WR IN and AIR OUT
buttons are in the out position.
For quieter operation
1. Set the Master Control Switch at
LO COOL.
2. Set the Thermostat Control at
desired number.
When the Thermostat Control is set
on 7 or 8 and the Fan is set on low
speed, moisture may freeze on the
coils and prevent the unit from
cooling. If this happens, set the Fan
at high speed and set the Thermostat
Control to a lower number.
3. Be sure the AIR IN and AIR OUT
buttons are in the out position.
For ni@ttime operation
During the cooler evening hours,
we recommend that you set the
Master Control Switch at LO COOL
for very quiet operation and the
Thermostat Control at mid-range
(4-5).
For efireme temperatures
For greatest economy and best
performance, we suggest that you
set the Master Control Switch at HI
COOL in extremely hot weather.
For ventilation
Whether the controls are set for
cooling or fan only operation,
setting the Ventilation Control at
AIR IN allows a small amount of
outside air to enter the room, and
setting it to AIR OUT lets room air
be exhausted to the outside. See
page 4. However, cooling
effectiveness is reduced whenever
the vent door is open, so we su~est
that you don't keep it open for long—
especially in hot, humid weather.
5
To adjust air direction
Up and down
The up-and-down air direction
louvers are controlled by fingertip
pressure on the louvers. They
regulate air discharge upward,
downward or straight out.
Side to side
on
CIRCULAIRE
off n
For fixed side-to-side air
direction, set the Circulaire Switch
to ON until the desired air direction
is obtained, then move it to OFF.
For continuous side-to-side air
circulation, set the Circulaire
Switch to ON and leave it there.