Thermostat Control; Selector Switch - GE APV04 Use And Care & Installation Manual

Operating Your Air Conditioner Controls
I I 1
4 5
~/ — \
2
\
THERMOSTAT

Thermostat Control

(on some models)
When you turn the Thermostat
Control to the desired setting, the
thermostat will automatically
control the temperature of the
indoor air. The higher the number
selected, the cooler the room air
will become.
For normal cooling
1. Set the Selector at HI COOL.
2. Set the Thermostat at desired
number (usually the midpoint is
a good starting position). If room
temperature is not satisfactory
after a reasonable time, set the
Thermostat Control at a higher
number for a cooler room or at a
lower number for a warmer room.
For quieter operation
1. Set the Selector at LO COOL.
2. Set the Thermostat at desired
number.
4
6
7
8

Selector Switch

(Appearance may vary slightly)
LO FAN provides low fan speed
operation without cooling.
HI FAN provides high fan speed
operation without cooling.
For matium cooling
1. Set the Selector at
2. Set the Thermostat at 8.
Inside
air hot
and
humid
If you
notice that your air
conditioner is not-cooling as it
should, it may be that ice has formed
SELECTOR
Outside air
temperature
OFF
turns air conditioner off.
Caution: If air conditioner is shut
off, wait at least two minutes
before restarting it.
high fan speed operation.
LO COOL provides cooling with
low fan speed operation.
For air circulation and
filtering without cooling
Set the Selector at LO FAN or
HI FAN.
the cooling coils. The ice blocks
on
air flow and stops the unit from
cooling the room. This "freezing
a temporary condition that most
is
often occurs at night when the
Thermostat is set on 7 or 8 and the
Selector is set on LO COOL.
To correct the condition, set the
Selector at
with the Thermostat at I or 2.
up"