Switching On The Iri 4010; Information Splash Screen - IriSys IRI 4010 User Manual

3.2 Switching on the IRI 4010

Figure 6: Switching on the IRI 4010

3.3 Information Splash Screen

The IRI 4010's splash screen appears for approximately 20 seconds when the imager is switched on. It
displays the time and date so the user can check that any images saved will be recorded with the correct time
and date. The time and date must be manually set (see Section 3.4.7.4).
   
•
The IRI 4010 features an On/Off power
button above the display. The IRI 4010 is
switched on and off by holding the power
button down for more than one second.
•
The IRI 4010 takes approximately twenty
seconds to become operational. During this
time a number of audible clicks will be heard.
This is normal as it is part of the calibration
procedure. After start-up these clicks
continue, but become much less frequent.
•
For best measurement results the imager
should be switched on at least 5 minutes
before use.
Figure 7: Splash Screen
Page 6 of 29
IPU 40108