Advertisement
Base
1
• Place the base on a flat surface.
Hint: You may need to rotate the base sockets so they are
upright, as shown.
Base
2
• Position the frame so that the wider end is down.
• Slide the ends of the frame into the sockets on the base. Push to
"snap" in place. Pull up on the frame to be sure it's secure in
the base.
Hint: The frame is designed to assemble to the base one way.
If you can remove the frame from the base, turn it around and
try again!
3
• Fit an armrest onto the seat bottom.
Hint: The armrests are designed to fit to the seat bottom one
way. If it does not seem to fit, try the other armrest.
• Repeat this procedure to assemble the other armrest.
Assembly
4
• Carefully turn the seat bottom over.
Frame
• Insert four #8-16 x 1,9 cm screws into the seat bottom and tighten.
Armrest
Seat Bottom
5
• Fit the seat bottom assembly onto the frame.
• Slide the seat bottom assembly down until you hear a "click".
4
#8-16 x 1,9 cm Screws
BACK VIEW
FRONT VIEW
Advertisement
