KitchenAid KOMS155MBL Technical Education page 41

6. Remove the four screws (2 at the top, and
2 at the bottom) from the inner door panel.
7. Start at the bottom, and press to release
the locking tabs along the inner door panel
while you pull out on the panel. Continue
around the door in a counterclockwise
direction until you are able to remove the
panel from the outer door panel.
8. Lift the inner door panel off the hinges and
remove it.
Top Inner Door Panel Screws
Bottom Inner Door Panel Screws
9. Lay the outer door panel on a padded
surface.
10. Remove the two screws from the display
assembly cover, then lift the cover at the
screw hole side, slide the opposite edge
out from under the tabs, and remove the
cover.
Display Cover Screws
Display Cover Tabs
11. Use a small-bladed screwdriver and pry
the 11-wire display connector away from
the board connector.
12. Pull out on the locking ring and release the
ribbon cable, then pull the cable out of the
connector.
13. Remove the display assembly from the
outer door panel.
Display Connector
REASSEMBLY NOTE: When mounting the
assembly to the outer door panel, make sure
that the notches in the color mask remain
aligned with the board holder pins, (left photo).
When you install the new display assembly, be
sure to keep the display glass and color insert
together (right photo), so the mask does not
become misaligned.
Color Mask
Color Mask Aligned
With Pins
4-19
Ribbon Cable Locking Ring
Display Glass
In Place