10. Disconnect the power supply cord.
11. Remove the cabinet.
12. Open the door and block it open.
13. To discharge high voltage capacitor, wait
for 60 seconds.
14. Disconnect the dummy resistor circuit from
the sensor connector of control panel.
15. Perform the necessary repairs.
To connector (F)
on Control Unit.
F-1
F-2
F-3
CONNECTOR
R1, R2 :
22
R3 : 4.3k
R4 :
1M
1
2
R1
3
R3
R2
Sensor Dummy Resistor Circuit
6-8
16. Reconnect all of the leads that were re-
moved from components during testing and
repairing.
17. Reinstall the cabinet.
18. Reconnect the power supply cord.
19. Run the oven and check all of the functions.
20. Repeat the "Water Load Cooking Test" on
page 6-6, and make sure that the unit
operates properly.
1% 1/2W
5% 1/4W
5% 1/4W
COM NO
NC
R4
Plunger
NC
NO
COM