Device Connections - D-Link DWL-3500AP Configuration Manual

1.5. Device Connections

At this point, all the devices are ready to be connected. After the switch discovers the APs, they
will appear on the Failed list because the MAC addresses of the APs are not configured in the
Valid AP database (i.e. the switch has not been configured to accept any valid APs).
1. Connect AP1 to port 1 of the switch
2. Connect AP2 to port 13 of the switch
3. Wait about 60 seconds and click Monitoring
Failed Access Points.
4. Select the APs to be managed and click Manage to add them to the valid AP database.
5. To verify the status of APs, click Monitoring
Points.
6. To view the local Valid AP database, click Administration
the Valid AP tab.
Note: The APs get into Failed Access Point list in about 60 seconds. After you select APs to
be managed, the APs enter to fully managed state in about 60 seconds.
Access Points Authentication
Access Point Managed Access
Basic Setup, then click