Table of Contents
Advertisement
DRYER 9577/9588
Vent Replacement
DLE9577/DLG9588
DISASSEMBLY/REPAIR
Page 49 of 58
1.
Use the VENT KIT to change
the exhaust direction.
(Part # 383EEL9001B)
On the back of the dryer,
remove the screw securing the
exhaust duct and pull it out.
2A.
Remove the knockout on the
left, right*, or bottom.
* The right vent option is not
available on gas dryers due to
internal piping interference.
2B.
Insert the replacement duct.
2C.
Attach it with a screw.
3.
Pre-assemble the elbow and
the other piece of duct and
secure the joint with duct tape.
4.
Insert the pre-assembled elbow
into the dryer through the side
vent hole and connect it to the
internal duct.
5.
Tear off some pieces of duct
tape about six inches long and
secure the internal joint.
6.
Connect the external vent pipe
to the dryer.
NOTE:
Be sure to use real duct
tape, which is heat-proof. Some
imitation products that look like
real duct tape but are not heat
sensitive are available and will
present a fire hazard.
TRAINING MANUAL
Advertisement
Table of Contents
