Table of Contents
Advertisement
DRYER 9577/9588
ELECTRICAL CONNECTION (Electric Dryer Only) (Continued)
ELECTRICAL CONNECTION (Gas Dryer Only)
The dryer requires a 120 V
at the factory and no user-intervention is required.
DLE9577/DLG9588
Be sure to tighten all screws firmly, but
do not strip them or distort the contact
area. Be sure to install a strain relief on
the power cord.
Replace the terminal block cover by
inserting the tabs into the slots and
letting them slide down to engage. Fold
it over to the back of the dryer so it
covers the access to the terminal block.
Be sure no wires are exposed or could
touch any metal surface.
Secure the cover with a screw.
single-outlet dedicated circuit. The cord is installed
AC
Page 16 of 58
TRAINING MANUAL
Advertisement
Table of Contents
