Table of Contents
Advertisement
DRYER 9577/9588
Warning! Do not attempt this alone! At least two people are required to lift the
dryer and place it properly on top of the washer. Failure to observe this warning
could result in serious physical injury and damage to the appliances.
DLE9577/DLG9588
INSTALLATION
Page 11 of 58
(STACKING KIT)
1.
Place the washer on a solid,
even floor. If you plan to use a
pedestal, install it now, before
going any further.
(See page 12.)
2.
Attach the side bracket loosely
to the top plate of the washer
but don't tighten the screw all
the way.
3.
Hold the bracket away from the
top plate and peel the protective
paper from the adhesive tape on
the side bracket. Hold the
adhesive surface off the top as
you tighten the screw. When the
screw is tight, attach the
adhesive tape to the top plate.
Repeat steps 2 and 3 for the
other side.
4.
Level the legs on the dryer on a
flat floor before setting the dryer
on top of the washer.
5.
Slide the dryer back into the
stops on the rails. Attach the
front bar with 2 screws to hold
the feet in place.
TRAINING MANUAL
Advertisement
Table of Contents
