Lap/Shoulder Belt Untwisting Procedure; Seat Belts In Passenger Seating Positions - Dodge Charger 2011 Owner's Manual

48 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
As a guide, if you are shorter than average you will
prefer a lower position, and if you are taller than average
you will prefer a higher position. When you release the
anchorage try to move it up and down to make sure that
it is locked in position.
In the rear seat, move toward the center of the seat to
position the belt away from your neck.

Lap/Shoulder Belt Untwisting Procedure

Use the following procedure to untwist a twisted lap/
shoulder belt.
1. Position the latch plate as close as possible to the
anchor point.
2. At about 6 to 12 in (15 to 30 cm) above the latch plate,
grasp and twist the belt webbing 180 degrees to create a
fold that begins immediately above the latch plate.
3. Slide the latch plate upward over the folded webbing.
The folded webbing must enter the slot at the top of the
latch plate.
4. Continue to slide the latch plate up until it clears the
folded webbing.

Seat Belts In Passenger Seating Positions

The seat belts in the passenger seating positions are
equipped with Automatic Locking Retractors (ALR)
which are used to secure a child restraint system. For
additional information refer to "Installing Child Re-
straints Using The Vehicle Seat Belt" under the "Child
Restraints" section. The chart below defines the type of
feature for each seating position.
Driver
First Row N/A
Second Row ALR
• N/A — Not Applicable
Center Passenger
N/A ALR
ALR ALR