Dodge Charger 2011 Owner's Manual page 308

306 UNDERSTANDING YOUR INSTRUMENT PANEL
REVERSE. To make your selection, press the Tilt Mirrors
in Reverse soft-key, select On or Off followed by pressing
the arrow back soft-key.
• Blind Spot Alert
When this feature is selected the Blind Spot Alert feature
can be set to Off, Lights or Lights and Chime. The Blind
Spot Alert feature can be activated in "Lights" mode,
when this mode is selected the Blind Spot Monitor (BSM)
system is activated and will only show a visual alert in
the outside mirrors. When "Lights & Chime" mode is
activated the Blind Spot Monitor (BSM) will show a
visual alert in the outside mirrors as well as an audible
alert when the turn signal is on. When "Off" is selected
the Blind Spot Monitor (BSM) system is deactivated. To
change the Blind Spot Alert status press the Off, Lights or
Lights & Chime soft-key followed by pressing the arrow
back soft-key.
NOTE: If your vehicle has experienced any damage in
the area where the sensor is located, even if the fascia is
not damaged, the sensor may have become misaligned.
Take your vehicle to an authorized dealer to verify sensor
alignment. Having a sensor that is misaligned will result
in the BSM not operating to specification.
• Parkview Backup Camera
Your vehicle may be equipped with the ParkView Rear
Back Up Camera that allows you to see an on-screen
image of the rear surroundings of your vehicle whenever
the shift lever is put into REVERSE. The image will be
displayed on the radio touchscreen display along with a
caution note to "check entire surroundings" across the
top of the screen. After five seconds this note will
disappear. The ParkView camera is located on the rear
of the vehicle above the rear License plate. To make your
selection, press the Parkview Backup Camera soft-key,
select On or Off followed by pressing the arrow back
soft-key.