Subaru LEGACY Service Manual page 53

• RHD model
1) Pull up parking brake lever and block tires.
2) Disconnect ground cable from battery.
3) Remove instrument panel lower cover from in-
strument panel.
4) Remove clevis pin which secures brake pedal to
brake booster operating rod. Also disconnect elec-
trical connectors (for stop light switch, etc.).
( B )
( A )
(A) Snap pin
(B) Clevis pin
5) Remove nuts and bolts which secure pedal
bracket.
(A) Brake pedal bracket
BRAKE PEDAL
2. AT MODEL
• LHD model
1) Pull up parking brake lever.
2) Disconnect ground cable from battery.
3) Remove instrument panel lower cover from in-
strument panel.
4) Remove clevis pin which secures brake pedal to
brake booster operating rod. Also disconnect stop
light switch connector.
5) Remove AT unit from brake panel (2 nuts).
6) Remove two bolts and four nuts which secure
brake pedal to pedal.
BR-00225
• RHD model
NOTE:
For removal procedures, refer to "MT MODEL".
<Ref. to BR-50, MT MODEL, REMOVAL, Brake
( A )
Pedal.>
B: INSTALLATION
1) Install in the reverse order of removal.
CAUTION:
• If cable clamp is damaged, replace it with a
new one.
BR-00226
• Never fail to cover outer cable end with boot.
• Be careful not to kink accelerator cable.
• Always use new clevis pins.
2) Adjustment of clutch pedal <Ref. to BR-53, AS-
SEMBLY, Brake Pedal.>
3) Inspect after pedal installation <Ref. to BR-53,
INSPECTION, Brake Pedal.>
BR-51
BRAKE
BR-00176