Motorola APX 3000 User Manual page 4

Sending an Emergency Call
1
Press the Emergency button.
2
Press and hold the PTT button. Speak clearly
with the microphone near your mouth.
3
Release the PTT button to end call.
4
Press and hold Emergency button to exit
emergency.
To exit emergency at any time, press and hold
the Emergency button.
Sending a Silent Emergency Alarm
1
Press the Emergency button.
2
The LED does not light up, and there is no
tone.
3
Silent emergency continues until you press
and hold the Emergency button to exit
emergency state.
OR
Press and release the PTT button to exit the
Silent Emergency Alarm mode and enter
regular dispatch or Emergency Call mode.
To exit emergency at any time, press and hold
the Emergency button.
LED Indicator
Solid red Radio is transmitting.
Radio is transmitting at low
Blinking red
battery condition.
Rapid blinking red Power-Up failure.
English
Radio has completed power
Solid green
up.
Blinking blue Bluetooth is powering On/
(3 Blinks) Off.
Slow blinking blue Bluetooth is ready to pair.
Rapid blinking
Bluetooth fails to connect or
blue for two
disconnect from a device.
seconds
Solid blue for two Bluetooth device is
seconds connected or disconnected.
Solid blue Bluetooth error.
Radio is connected with at
Blinking blue at
least one Bluetooth
heartbeat pace
accessory device.
Bluetooth Pairing with Mission Critical
Wireless Pod
1
To hear audio indications, plug the earpiece
into the Wireless Pod.
OR
To function as a Standalone PTT Device,
remove the earpiece.
2
Power on both your radio and Pod.
3
Ensure the Bluetooth feature of your radio and
Pod are enabled. Ensure the Pod is in pairing
mode.
4
Place the Bluetooth pairing spot of your Pod
within one inch from the Bluetooth pairing spot
on your radio.
Audio indications include alert tones and Voice
Announcement (feature enabled via CPS).
Bluetooth Pairing with Mission Critical
Wireless Remote Control Unit (RCU)
1
Verify that both your radio and your RCU are
powered ON and in pairing mode.
2
To enter pairing mode on your RCU, press and
hold the Trunk button while powering up the
RCU.
3
Place the Bluetooth pairing spot on your RCU
within one inch of the Bluetooth pairing spot
on your radio.
4
Radio LED turns solid blue for two seconds
and then blinking blue at heartbeat pace to
indicate connection is successfully
established.
PMLN6233_ Discreet Mission Critical Wireless
RCU is recommended to use with your
APX 3000 as it provides additional functionality
to this radio.
Connecting to Display Remote Speaker
Microphone (DRSM)
1
Turn off your Radio.
2
Align and attach the RSM's connector to your
radio's side connector.
3
Secure by tightening the screw on the lower
end of the connector.
Only DRSM supports the APX 3000 display
capability.