Removing Refrigerator Doors - Samsung Refrigerator User Manual

Hide thumbs Also See for Refrigerator:
Table of Contents

Advertisement

• Allow clearance to the right, left, back and
top when installing.
This will help reduce power consumption and
keep your energy bills lower.
• Do not install the Refrigerator where the
temperature will go below 50ºF (10ºC).
When moving your refrigerator
To prevent floor damage be sure the front leveling
legs are in the up position(above the floor).
Refer to 'ADJUSTING THE DOORS' in the manual
(at page 9)
FlOORING
For proper installation, this refrigerator must be
placed on a level surface of hard material that is
the same height as the rest of the flooring. This
surface should be strong enough to support
a fully loaded refrigerator, or approximately
660lbs(299kg). To protect the finish of the flooring,
cut a large section of the cardboard carton
and place under the refrigerator where you are
working. When moving, be sure to pull the unit
straight out and push back in straight.
REMOvING THE REFRIGERATOR
dOORS
If the Refrigerator is too large to pass through your
doorway easily, you can remove the refrigerator
doors.
Tools you will need(Not provided)
Philips
Flat-blade
screwdriver
screwdriver
Allen wrench
Pliers
(3/16") (5mm)
Disconnect power to the refrigerator
before removing the door or drawer.
WARNING
• Be careful not to drop, damage or scratch
the door/drawer while removing them.
• Be careful not to get injured while removing the
door/drawer.
• Reattach the door/drawer properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
- Wasting energy due to improper door seal.
Disassemble the Refrigerator doors
1. With the door opened, remove the Hinge Cover
cap
with a Flat head screwdriver, and close
1
the door. Remove the 3 screws holding down the
Hinge Cover and remove the Hinge Cover
1
2. Disconnect two connectors
the top cap and the one connector
door. Remove the tube
5
gray color part
of the water line coupler.
6
If a red clip is on the coupler, it must be
removed before removing the tube.
4
5
6
Wrench(10mm)
.
2
2
at each side of
3
on left side
4
with pressing the dark
3
_7
Setting up

Advertisement

Table of Contents
loading

Table of Contents