Using The Cold Water Dispenser; Controlling The Freezer Temperature; Controlling The Refrigerator Temperature - Samsung Refrigerator User Manual

Hide thumbs Also See for Refrigerator:
Table of Contents

Advertisement

uSING THE cONTROl pANEl
Basic temperature of Freezer and
Refrigerator Compartments
The basic temperature and/or recommended
temperature of Freezer and Refrigerator
Compartments are -19°C and 3°C respectively.
If the temperature of Freezer and Refrigerator
Compartments are too high or low, adjust the
temperature manually.

Controlling the Freezer temperature

The Freezer temperature can be set between -14ºC
and -22ºC to suit your particular needs. Press
the Freezer button repeatedly until the desired
temperature is shown in the temperature display.
Keep in mind that foods like ice cream may melt at
-15ºC. The temperature display will move sequentially
from -22ºC to -14ºC. When the display reaches
-14ºC, it will begin again at -22ºC.

Controlling the Refrigerator temperature

The Refrigerator temperature can be set between
7ºC and 1ºC to suit your particular needs. Press the
Fridge button repeatedly until the desired temperature
is shown in the temperature display.
The temperature control process for the Fridge works
just like the Freezer process.
Press the Fridge button to set your desired
temperature. After a few seconds, the Fridge will
begin adjusting towards the newly set temperature.
This will be reflected in the digital display.
- The temperature of the Freezer, Refrigerator
or pantry room may rise when you open the
doors too frequently, or if a large amount of warm
or hot food is placed inside.
- This may cause the digital display to blink. Once
the Freezer and Refrigerator temperature return to
their normal set temperatures, the blinking will stop.
- If the blinking continues, you may need to “reset”
the Refrigerator. Try unplugging the appliance, wait
for around 10 minutes and then plug the power
cord back in.
- The temperature of the pantry room may be a little
different according to the location inside.
- If communication between display and Main
Controller errors, Pantry display light may blink.
Once the pantry room return to their normal set
temperatures, the blinking will stop. If the blinking
continues for a long period of time, please contact
to Samsung Electronics Service Center.

uSING THE cOld WATER dISpENSER

Press the Ice / Water button to select the type of you
want.
No ICE
Select this if you want
to turn ice-maker off.
• Place a glass underneath the ice dispenser and
push gently against the dispenser lever with
your glass. Make sure the glass is in line with the
dispenser to prevent the ice from bouncing out.
• Please wait 2 seconds before removing the
glass under the dispenser to prevent spills. If the
Refrigerator door opens, the dispenser does not
work.
• When Cubed Ice is selected after using the
Crushed Ice feature, a small amount of residual
crushed ice might be produced.
• Water Dispenser Installation
After installation, press the dispenser arm for at
least 2 minutes to remove trapped air from the
water line and to fill the water system.
PUSH
• In case ice doesn’t come out, pull out the ice
bucket and press test button located on the right
side of ice-maker.
• Do not press the test button continuously when the
tray is filled with ice or water as illustration. Water
may overflow or ice jamming may occur.
• Normal Use
To fill ice bucket to maximum capacity after
installation, make sure to do the following steps.
1. Allow your refrigerator to operate and cool down
for 24 hours (or 1 full day).
2. Waiting 24 hours will allow your ice maker to
cool properly.
3. Dispense 4 to 6 ice cubes into the glass.
4. After 8 and 16 hours, dispense a full glass of ice
at each time.
_13
Operating

Advertisement

Table of Contents
loading

Table of Contents