Targa CR 1.0 A1 User Manual And Safety Information page 37

When LED light is enabled, the light will switch on automatically when required (when the ambient
light is insufficient).
Photo capture menu
The photo capture menu allows you to set the different still image recording parameters. How to
open the photo capture menu:
1. Power the device on by pressing and holding the On/Off button (14) for approx. 3 seconds.
2. By default, the "Loop recording" option appears. Press the + (18) or – (17) button several
times, select the "Photo" menu option and press OK (12) to open it.
3. Press the Menu button (11) to open the still image recording menu.
4. Use the – (17) and + (18) buttons to adjust the desired settings (see below) and press OK (12).
5. Press the Menu button (11) again to hide the menu.
The following sections contain a description of the different parameters available in the still image
capture menu.
Capture Mode
This allows you to define whether you wish to capture images with the Dashboard Camera
normally or using the self-timer. The delay times of 2 seconds, 5 seconds or 10 seconds are
available for the self-timer.
When the self-timer is enabled, the
(13) depending on the delay time selected
Resolution
The resolution determines the size of the recording in pixels. As a general rule: the higher the
resolution, the more storage space is required. The following settings are available:
Resolution
12M 4032x3024
10M 3648x2736
8M 3264x2448
5M 2592x1944
3M 2048x1536
2MHD 1920x1080
1.3M 1280x960
VGA 640x480
, or
Description
Very high quality
High quality
Very good quality
Good quality
Average quality
PC widescreen quality
Low quality
VGA screen quality
icon will be shown at the top of the display
CR 1.0 A1
English - 35