Pro-Form PETL70707.2 User Manual page 10

10. Insert the indicated connectors into the Right
Upright (78).
Next, insert the fronts of the brackets on the
Bridge (95) into the Uprights (74, 78), and then
fully insert the brackets. Make sure that the
plastic edges of the Bridge are inside the
Uprights. Be careful not to pinch the wires.
Attach the Bridge (95) with six 1/4" x 1/2" Bolts
(7) and six 1/4" Star Washers (10); start the two
indicated Bolts, then start the other four
Bolts, and then tighten all six Bolts.
See steps 5 and 7. Tighten the four 3/8" x 4 1/2"
Bolts (6).
11. With the help of a second person, hold the con-
sole assembly near the Bridge (95). Connect the
Bridge Wire (52) to the console assembly wire.
See the inset drawing in step 9. The connec-
tors should slide together easily and snap
into place. If they do not, turn one connector
and try again. IF THE CONNECTORS ARE
NOT CONNECTED PROPERLY, THE CON-
SOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.
Connect the Console Ground Wire (101) to the
console assembly ground wire. Insert the wires
into the console assembly.
Attach the console assembly with three 3/8" x
1 1/4" Bolts (5) and three 3/8" Star Washers (9).
Be careful not to pinch the wires.
10
7
10
7
Start
First
74
11
Console
Assembly
101
52
95
10
95
Connectors
Edge
7
10
Start
7
First
78
9
5
Front