Table of Contents
Advertisement
15. Message LED Lead (MSG.LED)
This indicates whether a message has been received from a fax/modem. The
LED will remain lit when there is no signal and blink when there is data transfer
or waiting in the inbox. This function requires ACPI OS and driver support.
16. SMI Suspend Switch Lead (SMI)
This allows the user to manually place the system into a suspend mode or "Green"
mode where system activity will be instantly decreased to save electricity and
expand the life of certain components when the system is not in use. This 2-pin
connector (see the figure below) connects to the case-mounted suspend switch.
If you do not have a switch for the connector, you may use the "Turbo Switch"
since it does not have a function. SMI is activated when it detects a short to open
moment and therefore leaving it shorted will not cause any problems. This may
require one or two pushes depending on the position of the switch.
17. ATX Power Switch / Soft Power Switch (PWR.SW)
The system power is controlled by a momentary switch connected to this lead.
Pushing the button once will switch the system between ON and SLEEP. Push-
ing the switch while in the ON mode for more than 4 seconds will turn the
system off. The system power LED shows the status of the system's power.
18. Reset Switch Lead (RESET)
This 2-pin connector connects to the case-mounted reset switch for rebooting
your computer without having to turn off your power switch. This is a preferred
method of rebooting to prolong the life of the system's power supply.
19. System Power LED (PWR.LED)
This 3-pin connector connects the system power LED, which lights when the
system is powered on and blinks when it is in sleep mode.
20. Keyboard Lock Switch Lead (KEYLOCK)
This 2-pin connector connects to the case-mounted key switch to allow key-
board locking.
21. Speaker Connector (SPEAKER)
This 4-pin connector connects to the case-mounted speaker.
P2V System Panel Connections
32
III. INSTALLATION
Message
LED
SMI Lead
ATX Power
Switch*
Reset SW
Requires an ATX power supply.
*
ASUS P2V User's Manual
+5 V
Power LED
+5 V
MLED
PLED
ExtSMI#
KEYLOCK
Keyboard Lock
Ground
Ground
PWR_SW
Ground
+5V
Speaker
Ground
Connector
ResetCon
Ground
Ground
SPKR
Advertisement
Table of Contents
