Troubleshooting Table; Declaration Of Conformity - McCulloch TRIMMAC 281 Instruction Manual

TROUBLESHOOTING TABLE

WARNING:
Always stop unit and disconnect spark plug before performing all of the
recommended remedies below except remedies that require operation of the unit.
TROUBLE CAUSE
Engine will not
1. ON/OFF switch in OFF
start.
position.
2. Engine flooded.
3. Fuel tank empty.
4. Spark plug not firing.
5. Fuel not reaching
carburetor.
6. Carburetor requires
adjustment.
Engine will 1. Carburetor requires
not idle adjustment.
properly. 2. Crankshaft seals worn.
3. Compression low.
Engine will not 1. Air filter dirty.
2. Spark plug fouled.
accelerate,
lacks power,
3. Carburetor requires
or dies under
adjustment.
a load.
4. Carbon build-up on
muffler outlet screen.
5. Compression low.
Engine 1. Choke partially on.
smokes 2. Fuel mixture incorrect.
excessively.
3. Air filter dirty.
4. Carburetor requires
adjustment.
Engine runs 1. Fuel mixture incorrect.
hot.
2. Spark plug incorrect.
3. Carburetor requires
adjustment.
4. Carbon build-up on
muffler outlet screen.

DECLARATION OF CONFORMITY

EC Declaration of Conformity relating to 2000/14/EC
We, Electrolux Home Products, Inc., Texarkana, TX, 75501, USA, Tél. : +1 903 223
4100, declare under sole responsibility that the McCulloch model TrimMac 281 grass
trimmer was assessed in accordance with Annex V of the DIRECTIVE and from serial
numbers 2004- -247N00001 and onwards, conforms to the provisions of the DIRECTIVE.
The cutting width is 431 mm. The measured sound power is 108 dB and the guaranteed
sound power is 114 dB.
Texarkana 04- -09- -03
REMEDY
1. Move ON/OFF switch to ON position.
2. See "Starting a Flooded Engine" in
Operation Section.
3. Fill tank with correct fuel mixture.
4. Install new spark plug.
5. Check for dirty fuel filter; replace.
Check for kinked or split fuel line;
repair or replace.
6. Contact an authorized service dealer.
1. See "Carburetor Adjustment" in
Service and Adjustments Section.
2. Contact an authorized service dealer.
3. Contact an authorized service dealer.
1. Clean or replace air filter.
2. Clean or replace plug
and regap.
3. Contact an authorized service dealer.
4. Contact an authorized service dealer.
5. Contact an authorized service dealer.
1. Adjust choke.
2. Empty fuel tank and refill with
correct fuel mixture.
3. Clean or replace air filter.
4. Contact an authorized service dealer.
1. Empty fuel tank and refill with
correct fuel mixture.
2. Replace with correct spark plug.
3. Contact an authorized service dealer.
4. Contact an authorized service dealer.
relating to 2000/14/EC
Michael S. Bounds, Director
Product Safety and Standards
14