Assembly Instructions - Fein Turbo I Instruction Manual

OBJ_BUCH-0000000150-003.book Page 13 Friday, February 28, 2014 11:08 AM

Assembly instructions.

Before mounting or replacing accessories, pull the mains plug. This preventive
WARNING
safety measure rules out the danger of injuries through accidental starting of the
vacuum cleaner.
Mount accessories applying only slight pressure. For disassembling, turn the parts somewhat
against each other and pull apart.
Mounting the casters (figure 3).
Mount the casters.
Inserting the fleece filter bag
(figure 4).
Open the fasteners on both sides and take off
the vacuum cleaner lid.
Grasp the new fleece filter bag by the card-
board flange, first at the bottom then at the
top, and slide it over the cog.
When inserting a fleece filter bag, take care
that the cardboard flange and the fleece filter
bag face completely against the inside wall of
the container.
Mount the vacuum cleaner lid again and close
the fasteners.
After removing the fleece filter bag, seal it with
the closing cover in order to avoid debris.
Mounting the nozzle holder (figure 5).
Mount the nozzle holder.
Fig. 3
Caster
Fleece filter bag
Fig. 4
Fig. 5
Nozzle holder
en
13
1x