What If None Of The Codes Work - Cisco AT6400 User Manual

5. Point the remote at the device, and press POWER to test the device.
6. Did the device power off?
• If YES, write this code number in the table found on page 38. You may need it again if the
device code is accidently erased.
• If NO, repeat this procedure from step 3 using a different setup code.
NOTE: If none of the codes listed for your brand of device operate the device correctly, go to
What If None of the Codes Work for instructions.
7. Repeat this procedure for each mode key you want to program.

8. WHAT IF NONE OF THE CODES WORK?

If none of the codes listed for your brand of device operate the device correctly, or if your device is
not listed in the codes table, you can use the Auto-Search function to search through the code library
for a valid code. This section provides procedures for using the Auto-Search function to search the
code library for TV, DVD, and AUX mode codes.
NOTE: Read the procedures in this section thoroughly before beginning. You need to be prepared to
observe the behavior of the remote.
AUTO-SEARCH FEATURES
Consider the following items when using Auto-Search:
• The Auto-Search function begins searching from the first code.
• If a valid code is not found, the green backlight blinks twice and the remote returns to normal
operation.
• If any other key is pressed except PLAY, ENTER, POWER, EXIT, REW, FF, or numeric keys 1
through 4 (when programming the AUX mode key), the mode key displays a long red flash
(error message) and the remote returns to normal operation.
• Should the remote time-out before you complete the Auto-Search function you must start
over. This is indicated by one long flash of the red LED.
• If the device is not listed and the Auto-Search function is unable to find a usable code, you may
need to use the original remote provided with the device.
AUTO-SEARCHING THE CODE LIBRARY FOR TV OR DVD MODE CODES (Program Code 922)
NOTE: This procedure only applies to TVs and DVDs.
1. Turn on the device that you want to assign to the TV or DVD key.
4
UNIVERSAL REMOTE CONTROL