Change Volume Control - Cisco AT6400 User Manual

Some common examples:
• To program the AUX key to operate your DVD player, press DVD and then AUX.
• To program the DVD key to operate your TV, press TV and then DVD.

10. CHANGE VOLUME CONTROL

By default, once the TV mode key is programmed with a valid code, the volume and mute buttons
control your TV. These keys adjust the volume of your TV higher, lower, or temporarily switch the
volume off (Mute), regardless of whether the remote is in STB, DVD, or AUX mode.
If you prefer, you can choose to have the volume and mute buttons always control a different device
rather than your TV, such as a home theater receiver. (See Controlling Volume for One Device
below.) Note that you must first program one of the mode keys, such as AUX, with a valid code for
that device.
Alternatively, you can choose to have the volume and mute buttons control different devices
when the remote is in different modes. For example, you might want to control the volume on
your TV when in TV mode, but the volume on your home theater receiver when in AUX mode. (See
Controlling Volume for Different Devices below.) Note that not all devices have volume controls, so
if you choose this option, the volume and mute button may do nothing in some modes, such as STB
and DVD.
CONTROLLING VOLUME FOR ONE DEVICE (Program Code 955)
1. Press and hold the STB key on the remote control.
2. Without releasing the STB key, press and hold the OK key.
3. Release both keys and all mode keys blink twice.
4. Enter the programming code 955 by pressing the numeric keys on the remote. The STB key
blinks twice indicating a successful entry.
5. Press and release the mode key for the device you want the volume keys to control. For
example, if you want to control volume through your TV, press and release TV. The selected
mode key blinks three times to indicate a successful entry.
6. The volume keys now control only one device whether you are in STB, TV, DVD, or AUX mode.
CONTROLLING VOLUME FOR DIFFERENT DEVICES (Program Code 955)
Complete steps 1 through 4 of the Controlling Volume for One Device procedure.
Press and release the ENTER key. The STB mode key blinks three times to indicate a successful entry.
UNIVERSAL REMOTE CONTROL
7